(ORMUS) How to make Powder from Wet Process
Reading a couple of sources online and also Chris Emmons book on Ormus: Modern Day Alchemy ( A must read if you are
serious about Ormus) and trying to figure out the best way to convert my white precipitate to a white powder.
Seen one way was using the oven at 275 degrees and let it dry out. In the book it says to just let it set out
covered with paper filer or cheese cloth to dry out which would be a very slow process.
One idea that I was thinking was using a dehydrator that use the top layer/layers farthest away from the heating
element to dry out the precipitate. Several advantages of this would be the amount you could do, the control of the
temperature, having a large stack of trays you could put your heat source farther away from the electrical heat
Please reply and give me any ideas on drying the wet process to a power form would be much appreciated.
Some have commented on putting precipitate in a glass container in a gas stove for a couple hours at 300 to
evaporate the water, leaving the white precipitate.
is me annealing a small portion of my white powder, I made it using the wet method with Masada Dead Sea salt.
I originally annealed it in the oven on self-clean cycle about seven
been dried at 350 degreed F for two hours.
the filtrate for a couple hours at 250 degrees Fahrenheit in a toaster oven